3.1 Handling Precautions
(1) Do not drop or give a strong impact to the case.
(2) Do not remove the printed-circuit board of the module from the
case.
Doing so may cause a failure.
(3) Be careful to prevent foreign matters such as cutting chips or wire
chips from entering the module.
Failure to do so may cause a fire, failure or malfunction.
(4) A protective film is attached to the module top to prevent foreign
matter such as wire chips from entering the module during wiring.
Do not remove the film during wiring.
Be sure to remove it for heat dissipation before system operation.
(5) Tighten the module fixing screws with the specified torque shown
below.
Insufficient tightening torque could result in short, failure or
malfunction.
(6) When mounting the module to the base unit, insert the module
fixing projection into the fixing hole in the base unit, and mount the
module with using the hole as a supporting point.
Incorrect module mounting may cause a malfunction, failure, or
drop of the module.
After mounting the Q68TD-G-H02 on the base unit, fix the module
with a module fixing bracket. (Refer to Section 3.1.1.)
(7) Always make sure to touch the grounded metal to discharge the
electricity charged in the body, etc., before touching the module.
Failure to do so may cause a failure or malfunctions of the module.
Table3.1 Tightening torque
Screw location Tightening torque range
Module fixing screw (M3 screw) 0.36 to 0.48N•m
Connector fixing screw (M2.6 screw) 0.20N•m
大型CPU扩展电缆 GT15-A370C12B-S1
编码器用电缆 MR-EKCBL20M-L
总线连接单元 GT15-QBUS2
扩展底板 A1S52B
连接器/端子台转换模块电缆 AC30TB
伺服电机 HC-KFS43BK
制动电阻 FR-BR-H15K
伺服马达 HA-LFS11K24B
编码器接头 MR-J3ENCBL5M-A1-L
连接器/端子台转换模块电缆 AC50TB-E
电磁制动器用接头套件 MR-BKCNS1
RS-422扩展板 FX3G-422-BD
扩展板 FX2N-CNV-BD
编码器电缆 MR-ENCBL30M-H
伺服放大器 MR-J3-100B
GT16触摸屏 GT1675M-STBA
连接电缆 FX-232CAB-1
伺服放大器 MR-J3-500B
DC 输入/晶体管输出模块 AJ65SBTB32-8DT
Q系列编程器ATA卡 Q2MEM-16MBA
制动电阻 FR-BR-H55K
电池 GT11-50BAT
伺服电机 HC-SFS353B
大型CPU扩展电缆 GT15-C30NB
伺服马达 HC-UFS202B
电磁制动器用电缆 MR-BKS1CBL2M-A2-L
CN4电缆 MR-H3CBL1M
模块 AJ35TP-BU
模拟量温度输入模块 AJ65SBT2B-64RD3
伺服放大器 MR-J3-200B