(1) Do not drop the module or cause it to receive strong impact.
(2) Do not remove the PCB of the module from its case.
Doing so may cause the module to fail.
(3) Always make sure to touch the grounded metal to discharge the
electricity charged in the body, etc., before touching the module.
Failure to do so may cause a failure or malfunctions of the module.
(4) Tighten the screws to the specified torque shown below.
Insufficient tightening torque could result in shorts, failures or
malfunction.
4.1 Mounting module fixing bracket
Hold the Q66DA-G with module fixing bracket after the Q66DA-G is
mounted to the base unit.
Screw location Tightening torque range
Module mounting screw (M3 screw) 0.36 to 0.48 N•m
FG terminal screw (M3 screw) 0.42 to 0.58 N•m
POINT
Make sure that the module fixing bracket is hooked on the 3rd slit
模块 AJ35PTC-CNV-GI
模块 AJ35PP-CNV-GI
AS-I主站模块 FX2N-32ASI-M
转换适配器 FX2NC-CNV-IF
外部输入/输出单元 GT15-DIOR
CCLink模块 AJ65BT-64DAI
模拟量输出模块 A68DAI-S1
中继模块 AJ65BT-RPI-10A
模块 AJ35PTC-CNV-SI
模拟量模块 AJ65VBTCU-68ADIN
模块 AJ71ID1-R4
模块 AD35ID2
仿真单元 A6SIM-X64Y64
适配器 Q6DIN1
ID接口模块 QD35ID1
速中断模块 A1SI61
中断模块 AI61-S1
中继模块 AJ65BT-RPI-10B
模块 AJ71ID2-R4
模块 A1SJ71ID2-R4
模块 AD35ID1
适配器 Q6DIN3
模块 AJ35PTC-CNV-SI
转换电缆 FX2N-CNV-IF
模块 A1SD32ID1
模块 A1SD35ID2
模块 A1SJ71ID1-R4
模块 AD32ID1
RS-232C通讯用模块 FX2N-232IF
适配器 Q6DIN1A