P920 No spec: 3D coord conv
Details There is no specification for 3-dimensional coordinate conversion.
Remedy - Check the specifications.
P921 Illegal G code at 3D coord
Details The commanded G code cannot be performed during 3-dimensional coordinate conversion
modal.
Remedy - Refer to "MITSUBISHI CNC 700/70 Series Programming Manual (Machining Center Sys-
tem)" for usable G commands.
- When the basic specification parameter "#1229 set01/bit3 (Initial constant surface speed)"
is enabled, disable the parameter or issue the constant surface speed control cancel (G97)
command.
P922 Illegal mode at 3D coord
Details A 3-dimensional coordinate conversion command was issued during a modal for which 3-di-
mensional coordinate conversion cannot be performed.
Remedy - Refer to "MITSUBISHI CNC 700/70 Series Programming Manual (Machining Center Sys-
tem)" for usable G commands.
P923 Illegal addr in 3D coord blk
伺服驱动器 MR-J2S-200A4
伺服电机电源用电缆 MR-PWS1CBL5M-A1-L
伺服电机 HC-MFS43
编码器用电缆 MR-EKCBL20M-H
伺服电机 HC-MFS23
编码器电缆 MR-JHSCBL2M-L
SSCNET Ⅲ 光纤 MR-J3BUS03M
PLC FX2N-32MS-E/UL
伺服电机 HC-MFS73
可编程控制器 FX1N-60MR-001
存储卡 FX-EEPROM-16
伺服放大器 MR-J2S-55KB4
PLC FX2N-32MT-E/UL
伺服马达 HF-MP43
编码器接头 MR-J3ENCBL5M-A1-L
PLC FX2N-32MR-001
PLC FX3U-64MT/ES-A
伺服控制器 MR-J2S-700B
PLC FX1S-14MT-001
CN4电缆 MR-H3CBL1M
伺服电机电源用电缆 MR-PWS1CBL10M-A1-H
PLC FX2N-32MT-ES/UL
伺服电机 HC-MFS13D
编码器电缆 MR-JCCBL30M-L
PLC FX1S-14MT-D
Q系列PLC线性快闪存储卡 Q2MEM-4MBF
接头套件 MR-ECN1
PLC FX2N-48MT-DSS
RGB输出单元 GT16M-ROUT
PLC FX3U-32MR/DS