If the operation start position is set in a block which is in the middle of the program and the program is
started, the program before the set block is not executed. Please confirm that G and F modal and
coordinate values are appropriate. If there are coordinate system shift commands or M, S, T and B
commands before the block set as the start position, carry out the required commands using the MDI, etc.
If the program is run from the set block without carrying out these operations, there is a danger of
interference with the machine or of machine operation at an unexpected speed, which may result in
breakage of tools or machine tool or may cause damage to the operators.
Under the constant surface speed control (during G96 modal), if the axis targeted for the constant surface
speed control (normally X axis for a lathe) moves toward the spindle center, the spindle rotation speed will
increase and may exceed the allowable speed of the workpiece or chuck, etc. In this case, the workpiece,
etc. may jump out during machining, which may result in breakage of tools or machine tool or may cause
damage to the operators.
GT16触摸屏 GT1695M-XTBD
可编程控制器 FX1N-40MT-001
伺服马达 HA-LFS22K1M
伺服马达 HF-MP13
MODBUS模块 QJ71MT91
PLC FX3U-48MT/ES-A
编码器接头 MR-J3JCBL03M-A1-L
伺服放大器 MR-J2S-700A4
模拟量输入模块 AJ35T-M08B-R
伺服控制器 MR-J2S-30KA4
对应SSCNET定位模块 QD75M1
伺服控制器 MR-J2S-22KA
伺服放大器 MR-J3-70B
PLC FX2N-48MR-DS
伺服电机电源用电缆 MR-PWS1CBL5M-A2-H
PLC FX2N-64MT-ESS/UL
PLC FX1N-24MT-D
伺服控制器 MR-J2S-22KA4
GT16触摸屏 GT1665M-STBA
伺服放大器 MR-J3-500B
电源连接器 MR-PWCNS2
编码器电缆 MR-JHSCBL20M-L
伺服马达 HF-MP053B
伺服放大器 MR-J3-350B
编码器电缆 MR-JHSCBL30M-H
伺服马达 HA-LFS701M4
伺服驱动器 MR-J2S-15KB4
伺服控制器 MR-J2S-15KA
显示模块 FX1N-5DM
伺服驱动器 MR-J2S-60A4