CAUTION
ment correctly and securely. Otherwise, the servo motor may misoperate.
power capacitor, surge absorber or radio noise filter (FR-BIF option) between the servo
o amplifier.
tput terminals (U, V, W) correctly. Otherwise, the servo motor will operate improperly.
rvo motor power terminal (U, V, W) to the servo motor power input terminal (U, V, W)
let a magnetic contactor, etc. intervene.
U
Servo motor
M V
W
U
V
W
U
M V
W
U
V
W
ervo amplifier Servo motor Servo amplifier

AC power directly to the servo motor. Otherwise, a fault may occur.
orbing diode installed on the DC output signal relay of the servo amplifier must be wired in
rection. Otherwise, the emergency stop (EMG) and other protective circuits may not
COM
(24VDC)
RA
Control
output
signal
RA
COM
(24VDC)
Control
output
signal
Servo amplifier Servo amplifier

e is not tightened enough to the terminal block (connector), the cable or terminal block
ay generate heat because of the poor contact. Be sure to tighten the cable with specified
伺服放大器 MR-J2S-11KA
伺服驱动器 MR-J2S-22KB4
伺服控制器 MR-J2S-30KB
伺服控制器 MR-J2S-11KB4
伺服控制器 MR-J2S-15KA4
伺服驱动器 MR-J2S-37KB4
伺服控制器 MR-J2S-700B
伺服驱动器 MR-J2S-100A4
伺服放大器 MR-J2S-500A4
伺服控制器 MR-J2S-37KA
伺服控制器 MR-J2S-30KA4
伺服控制器 MR-J2S-22KA
伺服放大器 MR-J2S-70A
伺服放大器 MR-J2S-100A
伺服放大器 MR-J2S-700A4
伺服驱动器 MR-J2S-10B
伺服控制器 MR-J2S-500A
伺服驱动器 MR-J2S-40A
CC-Link接口单元 MR-J2S-T01
伺服控制器 MR-J2S-22KA4
伺服驱动器 MR-J2S-60A4
伺服驱动器 MR-J2S-350A4
伺服驱动器 MR-J2S-60B
伺服控制器 MR-J2S-700A
伺服控制器 MR-J2S-15KA
伺服驱动器 MR-J2S-30KB4
伺服驱动器 MR-J2S-60B4
伺服控制器 MR-J2S-500B
伺服控制器 MR-J2S-350B
伺服放大器 MR-J2S-100B