[WIRING PRECAUTIONS]
CAUTION
For wiring and connection, properly crimp or solder the connector with the tools specified by the
manufactures and attach the connector to the module securely.
Be careful to prevent foreign matter such as dust or wire chips from entering the module.
Failure to do may cause a fire, failure or malfunction.
A protective film is attached to the module top to prevent foreign matter such as wire chips from
entering the module during wiring.
Do not remove the film during wiring.
Be sure to remove it for heat dissipation before system operation.
Be sure to place the cables connected to the module in a duct or clamp them.
If not, dangling cables may swing or inadvertently be pulled, resulting in damage to the module and/
or cables, or malfunctions due to poor cable connection.
When disconnecting the cable, do not pull it by holding the cable part.
Disconnect the cable with connector with holding the connector plugged into the module.
Pulling the cable part with the cable still connected to the module may cause a malfunction or
damage to the module and/or cable.
伺服电机 HC-SFS121B
薄型主基板 Q32SB
伺服电机 HC-RFS203
串行通信模块 A1SJ71QC24N
伺服马达 HA-LFS11K1M4
输入模块 A70PL-S3
输入模块 AJ65SBTB1-32D
伺服驱动器 MR-J2S-55KA4
输入输出模块 A1SH42P-S1
模拟量输入输出模块 A1S63ADA
运动CPU单元 A73CPUP21-S1
编码器接头 MR-J3ENSCBL30M-L
扩展电源单元 FX3U-1PSU-5V
保护膜 GT15-70PSCB
保护膜 GT11-50PSCW
PLC FX3U-16MT/DS
伺服电机 HC-KFS053BD
底板 A1S38HBEU
模块 A1SD35ID1
伺服驱动器 MR-J2S-45KA4
伺服电机 HC-SFS7024
模块 A1SJ71ME81
PLC FX2N-48MT-ES/UL
PLC FX1S-20MR-DS
输入输出模块 A1SJ-56DR
背光灯 GT16-60SLTT
附件 MR-J2HBUS1M
运动CPU单元 A73CPUR21-S1
伺服马达 HA-LFS45K1M4
伺服控制器 MR-J2S-15KA