A - 1
[DESIGN PRECAUTION]

DANGER
Do not write data into the "system area" of the buffer memory of intelligent function modules.
Also, do not use any "prohibited to use" signals as an output signal to an intelligent function
module from the programmable controller CPU.
Writing data into the "system area" or outputting a signal for "prohibited to use" may cause a
malfunction of the programmable controller system.
CAUTION
Do not bunch the control wires or communication cables with the main circuit or power wires, or
install them close to each other.
They should be installed 100mm(3.9inch) or more from each other.
Not doing so could result in noise that may cause malfunction.
At power ON/OFF, voltage or current may instantaneously be output from the output terminal of
this module. In such case, wait until the analog output becomes stable to start controlling the
external device.
编码器接头 MR-J3ENSCBL20M-H
SSCNET Ⅲ 光纤 MR-J3BUS20M-A
输入输出模块 FX2N-8ER-ES/UL
伺服电机 HC-MFS053B
模块 AJ71J92-S3
电磁制动器用电缆 MR-BKS1CBL2M-A1-L
CPU单元 A1SJCPU-S3
扩展电源单元 FX3U-1PSU-5V
串行通信单元 GT15-RS4-9S
定位控制模块 A1SD75P3-S3
伺服电机 HC-SFS353B
伺服电机 HC-SFS102B
PLC FX1S-20MR-001
伺服马达 HA-LFS701M
保护膜 GT10-30PSGW
伺服马达 HC-RFS103K
伺服电机 HC-KFS23B
伺服电机电源用电缆 MR-PWS2CBL03M-A1-L
SSCNET Ⅲ 光纤 MR-J3BUS015M
Ethernet模块 A1SJ71E71N-B5
PLC FX3U-16MT/DS
GOT到GOT长距离连接电缆 GT15-C100BS
伺服放大器 MR-J2S-100A
PLC FX3U-16MT/DSS
As-i模块 QJ71AS92
保护膜 GT15-60PSCB
可控硅输出模块 AJ35PTF-24S
扩展电缆 A1SC07NB
输入模块 AJ65SBTB1-8D
伺服放大器 MR-J2S-70B