SIGN PRECAUTIONS]
!

DANGER
When overcurrent which exceeds the rating or caused by short-circuited load flows in the output
module for a long time, it may cause smoke or fire. To prevent this, configure an external safety
circuit, such as fuse.

Build a circuit that turns on the external power supply when the PLC main module power is
turned on. If the external power supply is turned on first, it could result in erroneous output or
erroneous operation.

When there are communication problems with the data link, refer to the corresponding data link
manual for the operating status of each station. Not doing so could result in erroneous output or
erroneous operation.

When connecting a peripheral device to the CPU module or connecting a personal computer or
the like to the intelligent function module to exercise control (data change) on the running PLC,
configure up an interlock circuit in the sequence program to ensure that the whole system will
always operate safely.
Also before exercising other control (program change, operating status change (status control))
on the running PLC, read the manual carefully and fully confirm safety.
Especially for the above control on the remote PLC from an external device, an immediate
action may not be taken for PLC trouble due to a data communication fault.
In addition to configuring up the interlock circuit in the sequence program, corrective and other
actions to be taken as a system for the occurrence of a data communication fault
伺服马达 HF-KP43B
伺服马达 HF-SP81B
保护膜 GT15-90PSCW
运动CPU单元 A73CPU-S3
DC 输入/继电器输出模块 AJ35PTF-56DR
参数单元 FR-PU07-BB
速计数模块 QD63P6
模拟量输入用适配器 FX3U-4AD-ADP
CPU单元 Q2ACPU
冗余CPU Q25PRHCPU
伺服电机电源用电缆 MR-PWS1CBL2M-A1-L
FA设备连接继电器电缆 GT11H-C15R4-25P
RS-485适配器 FX3U-485ADP
CPU单元 A1NCPU
CPU单元 A0J2HCPUR21
脉冲输出模块 FX2N-10PG
编码器反馈、主轴定向、定位模块 FR-A7AP
保护膜 GT16-90PSGW
CPU单元 A3ACPU
运动CPU单元 A73CPUP21-S1
伺服电机电源用电缆 MR-PWS1CBL2M-A2-H
电源模块 A66P
保护膜 GT16-90PSCW
通道间隔离脉冲输入模块 QD60P8-G
扩展板 FX3G-CNV-ADP
SI/QSI光缆型模块 QJ71LP21-25
存储卡 FX-EPROM-8
带底板的CPU Q00JCPU
保护膜 GT15-80PSGB
晶体管输出模块(源型) QY81P