WARNING
Before wiring or inspection, switch power off and wait for more than 15 minutes. Then, confirm th
is safe with voltage tester. Otherwise, you may get an electric shock.
Connect the servo amplifier and servo motor to ground.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and servo motor until they have been installed. Otherw
may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an elec
2. To prevent fire, note the following:
CAUTION
Do not install the servo amplifier, servo motor and regenerative brake resistor on or near combus
Otherwise a fire may cause.
When the servo amplifier has become faulty, switch off the main servo amplifier power side. Con
flow of a large current may cause a fire.
3. To prevent injury, note the follow
CAUTION
控制器放大器总线电缆 MR-J2CN1-A
CC-Link接口单元 MR-J2S-T01
伺服驱动器 MR-J2S-20A
附件 MR-J2HBUS1M
伺服控制器 MR-J2S-500A
接线端子块电缆 MR-J2TBL1M
伺服驱动器 MR-J2S-200A4
伺服驱动器 MR-J2S-37KB4
伺服控制器 MR-J2S-15KB
伺服放大器 MR-J2S-11KA4
伺服控制器 MR-J2S-22KA4
伺服控制器 MR-J2S-30KB
伺服放大器 MR-J2S-55KB4
伺服控制器 MR-J2S-22KA
控制器放大器总线电缆 MR-J2HBUS05M-A
伺服控制器 MR-J2S-700A
伺服放大器 MR-J2S-200B4
控制器放大器总线电缆 MR-J2HBUS1M-A
伺服放大器 MR-J2S-500A4
附件 MR-J2HBUS5M
伺服控制器 MR-J2S-11KB
伺服控制器 MR-J2S-15KA
伺服控制器 MR-J2S-11KB4
伺服驱动器 MR-J2S-30KB4
附件 MR-J2CN3TM
伺服控制器 MR-J2S-37KB
伺服放大器 MR-J2S-700A4
伺服驱动器 MR-J2S-40A
伺服控制器 MR-J2S-350B
伺服驱动器 MR-J2S-10A