[DESIGN PRECAUTIONS]
DANGER
z Do not write data to the "System Area" in the intelligent function module's
buffer memory. Also, do not turn the output for signals for "Use Prohibited"
signals among the output signals from the PLC CPU to the intelligent
function module (ON).If data are written to the "System Area" or output in
response to "Use Prohibited" signals, there is danger that the PLC system
will malfunction.

CAUTION
z Do not bunch the control wires or communication cables with the main circuit
or power wires, or install them close to each other. They should be installed
100mm (3.94 in.) or more from each other. Not doing so could result in noise
that may cause malfunction.
z If a BASIC program is registered in the EEP-ROM in the module, do not
perform a power OFF or PLC CPU reset operation at the station where the
module is installed during registration. If a power OFF or PLC CPU reset
operation is performed at the station where the module is installed during
registration, the data contents in the EEP-ROM will be indefinite and it will be
necessary to reset the setting values, etc. in the buffer memory and register
them again in the EEP-ROM. It could also cause the module to break down
or malfunction.
[INSTALLATION PRECAUTIONS]
CAUTION
z Use the PLC in an environment that meets the general specifications
中断模块 QI60
模块 AD32ID2
CCLink模块 AJ65BT-64DAI
适配器 Q6DIN3
仿真单元 A6SIM-X64Y64
模块 AJ71ID2-R4
模拟输出模块 A616DAI
ID接口模块 QD35ID2
模块 A1SD35ID1
模块 A1SD32ID1
模拟量输出模块 Q68DAV，Q68DAI
模块 A1SD35ID2
适配器 Q6DIN1
中继模块 AJ65BT-RPI-10B
模块 AJ35PTC-CNV-SI
中断模块 AI61-S1
外部输入/输出单元 GT15-DIOR
ID接口模块 QD35ID1
模块 AJ35PTC-CNV-GI
转换电缆 FX2N-CNV-IF
中断模块 AI61
模块 AJ35PTC-CNV-SI
AS-I主站模块 FX2N-32ASI-M
模拟量输入模块 Q68ADV，Q68ADI
模拟量模块 AJ65BT-64DAI
模拟量模块 AJ65VBTCU-68ADIN
模块 AJ71ID1-R4
中继模块 AJ65BT-RPI-10A
适配器 Q6DIN1A
模拟量输出模块 A1S68DAI