DANGER
(Read these precautions prior to use.)
When using Mitsubishi equipment, thoroughly read this manual and the
associated manuals that are introduced in this manual. Also, pay
careful attention to safety and handle the module properly.
These precautions apply only to Mitsubishi equipment. Please refer to
the relevant user’s manuals for safety precautions pertaining to
Mitsubishi programmable controller systems and GOT-A900 Series
Graphics Operation Terminal (abbreviated as GOT, hereafter).
The SAFETY PRECAUTIONS in this manual are classified into two
categories: DANGER and CAUTION.
: Procedures which may lead to a dangerous condition
and cause death or serious personal injury if not
observed as directed.
: Procedures which may lead to a dangerous condition
and cause minor to medium personal injury or
damage only to property, if not observed as directed.
Depending on circumstances, procedures indicated with CAUTION
could also lead to serious results.
In any case, it is important to strictly observe the directions indicated
with the above signs.
Keep this manual in a place which allows you to easily reach it
whenever necessary. Please make sure that the end user of this
equipment be provided with this manual.
[PRECAUTIONS FOR INSTALLATION]
DANGER
z Make sure to shut off all the phases of the system power supply
externally before installing a power supply module, wiring, or
working on the GOT. There may be a hazard of electric shock or
damage to the GOT unless all the phases of the system power
supply are shut off.
z Make sure to apply the terminal cover to the GOT if the power is to
be supplied to the GOT after completing wiring work on the GOT’s
power supply terminal. There may be a hazard of electric shock
unless the cover is installed.
CAUTION
z Use the GOT in an environment which satisfies the general
specifications described in the GOT-A900 Series User’s Manual.
Using in an environment other than that satisfies the general
specifications could cause an electric shock, a fire, or damage or
deterioration to the GOT.
z Be extremely cautious so that your finger, etc. will not be caught
when adjusting the installing angle after removing the angle
CAUTION
网络模块 AJ71LP21G
变频器 FR-A740-90K-CHT
输入模块 AX81C
输出模块 AY51-S1
可控硅输出模块 AJ35PTF-24S
伺服马达 HA-LFS15K24
DC 输入模块 AJ65VBTS3-32D
附件 GT15-60ATT-87
晶体管输出模块 AJ65SBTC1-32T1
DC 输入模块 AJ65FBTA4-16DE
伺服控制器 MR-J2S-15KA
小型CPU扩展电缆 GT15-A1SC30B
运动CPU单元 A73CPU
交流电抗器 FR-HAL-H11K
变频器 FR-A740-110K-CHT
CC-Link模块 A1SJ61QBT11
速计数模块 AD61S1
伺服马达 HA-LFS8014
定位模块 AD75M2
定位控制模块 A1SD75M1
继电器输出模块 AJ35PJ-8R
RS-485适配器 FX2NC-485ADP
伺服马达 HA-LFS22K2B
速计数模块 AJ65BT-D62D
伺服马达 HA-LFS6014
电流输入模拟量模块 Q66AD-DG
模拟量输入输出模块 FX0N-3A
交流电抗器 FR-HAL-H560K
连接电缆 AC30TE
模拟量输入模块 A84AD