(Note 1) Inch/metric conversion is performed in either of 2 ways: conversion from the parameter
screen (#1041 I_inch: valid only when the power is turned ON) and conversion using the
G command (G20 or G21).
However, when a G command is used for the conversion, the conversion applies only to
the input command units and not to the input setting units.
Consequently, the tool offset amounts and other compensation amounts as well as the
variable data should be preset to correspond to inches or millimeters.
(Note 2) The millimeter and inch systems cannot be used together.
(Note 3) During circular interpolation on an axis where the input command units are different, the
center command (I, J, K) and the radius command (R) can be designated by the input
setting units. (Use a decimal point to avoid confusion.)

伺服电机 HC-KFS43K
伺服放大器 MR-J2S-11KA4
变频器 FR-A740-37K-CHT
伺服电机 HC-KFS053D
伺服电机 HC-MFS13BD
伺服放大器 MR-J2S-700A4
伺服电机 HC-MFS43K
伺服驱动器 MR-J2S-100A4
伺服驱动器 MR-J2S-40A
伺服驱动器 MR-J2S-37KA4
伺服驱动器 MR-J2S-60A
伺服控制器 MR-J2S-500B
伺服驱动器 MR-J2S-60A4
直流电抗器 FR-HEL-H37K
伺服驱动器 MR-J2S-20A
伺服驱动器 MR-J2S-10B
伺服放大器 MR-J2S-500A4
伺服放大器 MR-J2S-70B
伺服驱动器 MR-J2S-60B
伺服放大器 MR-J2S-200B4
伺服电机 HC-MFS43BK
伺服放大器 MR-J2S-200B
伺服放大器 MR-J2S-100B4
伺服电机 HC-MFS23BK
伺服电机 HC-MFS23K
伺服控制器 MR-J2S-22KA4
伺服驱动器 MR-J2S-15KB4
伺服放大器 MR-J2S-100A
伺服电机 HC-KFS73BK
伺服电机 HC-KFS23K