DANGER
Not applicable in this manual.


WARNING
1. Items related to operation
If the operation start position is set in a block which is in the middle of the program and
the program is started, the program before the set block is not executed. Please
confirm that G and F modal and coordinate values are appropriate. If there are
coordinate system shift commands or M, S, T and B commands before the block set as
the start position, carry out the required commands using the MDI, etc. If the program is
run from the set block without carrying out these operations, there is a danger of
interference with the machine or of machine operation at an unexpected speed, which
may result in breakage of tools or machine tool or may cause damage to the operators.
Under the constant surface speed control (during G96 modal), if the axis targeted for
the constant surface speed control moves toward the spindle center, the spindle
rotation speed will increase and may exceed the allowable speed of the workpiece or
chuck, etc. In this case, the workpiece, etc. may jump out during machining, which may
result in breakage of tools or machine tool or may cause damage to the operators.

PLC FX2N-64MT-ESS/UL
PLC FX1N-14MR-ES/UL
总线连接单元 GT15-QBUS2
小型CPU长距离连接电缆 GT15-C100EXSS-1
DC型输入模块 QX81-S2
保护膜 GT10-40PSGW
PLC FX1S-20MR-D
伺服马达 HA-LFS15K2B
伺服放大器 MR-J2S-55KB4
PLC FX3G-24MT/ES-A
保护膜 GT11-50PSCB
薄型主基板 Q32SB，Q33SB，Q35SB
DC型输入模块(弹簧夹接线端子) QX80-TS
输出模块 AY42-S4
伺服马达 HA-LFS25K1
晶体管输出模块 AJ65VBTS2-16T
CPU基板 A1S38B
网络模块 A1SJ71QE71N-B5T
智能型通信模块 A1SD51S
PLC FX2N-16MS
扩展底板 A1S65B
网络模块 A1SJ71BR11
PLC FX1S-14MR-D
PLC FX2N-80MT-ESS/UL
PLC FX3U-80MT/ESS
运动CPU单元 A73CPUP21-S3
扩展基板 A1S58B-S1
伺服电机 HC-KFS13B
CPU单元 A1SJCPU
PLC FX1S-30MR-DS