CAUTION
z Use the PLC in the environment given in the general specifications section
of the user's manual to be used. Using the PLC outside the range of the
general specifications may result in electric shock, fire, or erroneous
operation or may damage or degrade the product.
z Insert the fixing latch on the bottom of the module into the fixing hole in the
base unit and install the module using the hole point as a fulcrum. (The
Q2AS series module shall be fastened by screws in the base unit at the
specified torque.)
Not installing the module correctly could result in erroneous operation,
damage, or pieces of the product falling.
z Tighten the screw within the range of specified torque.
If the screws are loose, it may result in fallout, short circuits or malfunction.
Tightening the screws to far may cause damage to the screw and/or the
module, resulting in fallout, short circuits or malfunction.
z Shut off all phases of the external power supply in the system before
mounting or dismounting the module.
If you do not switch off the external power supply, it will cause electric
shock or damage to the product.
z Do not touch the electronic parts or the module conducting area directly.
It may cause erroneous operation or failure.
电压输入模拟量模块 Q68ADV
差动输出定位模块(升级版) QD75D1N
Q系列PLC编程电缆 QC30R2
接口板 Q80BD-J61BT11N
带以太网类型的Q系列CPU Q13UDEHCPU
差动输出定位模块 QD75D4
扩展电缆 QC06B
速计数模块 QD64D2
SI/QSI光缆型模块 QJ71LP21-25
电源冗余系统扩展基板 Q68RB
扩展基板 Q63B
CPU单元 Q2ACPU
Profibus模块 QJ71PB92D，QJ71PB93D
网络模块 AJ71QLR21
电压/电流输出模拟量模块 Q62DA-FG
ID接口模块 QD35ID1
网络模块 A1SJ71QLR21
QCPU（Q模式）用总线连接电缆 GT15-QC30B
继电器输出模块 QY10
老款小A系列扩展基板 QA1S51B
老款小A系列主基板 QA1S33B
对应SSCNET定位模块 QD75M1
闪存卡 QD81MEM-512MBC
扩展基板 Q612B
更换用大容量电池模块 Q8BAT
定位模块(升级版) QD75P4N
热电偶型温度输入模块 Q68TD-G-H01
电压/电流输出模拟量模块 Q66DA-G
晶体管输出模块(弹簧夹接线端子) QY40P-TS
性能型QCPU Q02CPU