Never open the front case or terminal covers while the power is ON or the unit is running, as this
may lead to electric shocks.
Never run the unit with the front case or terminal cover removed. The high voltage terminal and
charged sections will be exposed and may lead to electric shocks.
Never open the front case or terminal cover at times other than wiring work or periodic
inspections even if the power is OFF. The insides of the Motion controller and servo amplifier are
charged and may lead to electric shocks.
Completely turn off the externally supplied power used in the system before mounting or
removing the module, performing wiring work, or inspections. Failing to do so may lead to electric
shocks.
When performing wiring work or inspections, turn the power OFF, wait at least ten minutes, and
then check the voltage with a tester, etc.. Failing to do so may lead to electric shocks.
Be sure to ground the Motion controller, servo amplifier and servomotor. (Ground resistance :
100 or less) Do not ground commonly with other devices.
The wiring work and inspections must be done by a qualified technician.
Wire the units after installing the Motion controller, servo amplifier and servomotor. Failing to do
so may lead to electric shocks or damage.
Never operate the switches with wet hands, as this may lead to electric shocks.
Do not damage, apply excessive stress, place heavy things on or sandwich the cables, as this
may lead to electric shocks.
Do not touch the Motion controller, servo amplifier or servomotor terminal blocks while the power
is ON, as this may lead to electric shocks.
Do not touch the built-in power supply, built-in grounding or signal wires of the Motion controller
and servo amplifier, as this may lead to electric shocks.
QCPU（Q模式）用总线连接电缆 GT15-QC50B
WEB服务器模块 QJ71WS96
对应SSCNET定位模块 QD75M4
定位模块 QD70P8
网络模块 AJ72QLP25G
定位模块(升级版) QD75P1N
GI-62.5/125光缆型模块 QJ72LP25GE
晶体管输出模块(弹簧夹接线端子) QY40P-TS
Q总线电缆用氧化铁磁芯组（两副） GT15-QFC
大型主基板 Q38BL-E
CPU单元 Q2ASHCPU
闪存卡 QD81MEM-1GBC
热电偶型温度输入模块 Q64TDV-GH
CPU单元 Q4ARCPU
热电偶型温度输入模块 Q68TD-G-H01
主站/本地站模块 QJ61BT11
主基板 Q33B
总线连接单元 GT15-75QBUS2L
薄型主基板 Q32SB
性能型CPU Q02CPU，Q06HCPU，Q25HCPU
C语言的控制单元 Q06CCPU-V-B
速计数模块 QD62D
串行通信模块 A1SJ71QC24N
扩展基板 Q612B，Q63B，Q55B
晶体管输出模块(独立) QY68A
老款小A系列主基板 QA1S38B
以太网模块 AJ71QE71N-B5T
对应SSCNET III定位模块 QD75MH1
输入模块 QX10，QX28，QX40
电压/电流输出模拟量模块 Q62DAN