Never run the unit with the front case or term inal cover removed. The high voltage terminal and
charged sections will be exposed and may lead to electric shocks.
Never open the front case or terminal cover at times other than wiring work or periodic
inspections even if the power is OFF. The insides of the Motion controller and servo amplifier are
charged and may lead to electric shocks.
When performing wiring work or inspections, turn the power OFF, wait at least ten minutes, and
then check the voltage with a tester, etc.. Faili ng to do so may lead to electric shocks.
Be sure to ground the Motion controller, servo amplifier and servomotor. (Ground resistance :
100 or less) Do not ground commonly with other devices.
The wiring work and inspections must be done by a qualified technician.
Wire the units after installing the Motion controller, servo amplifier and servomotor. Failing to do
so may lead to electric shocks or damage.
Never operate the switches with wet hands, as this may lead to electric shocks.
Do not damage, apply excessive stress, place heav y things on or sandwich the cables, as this
may lead to electric shocks.
Do not touch the Motion controller, servo amplifier or servomotor terminal blocks while the power
is ON, as this may lead to electric shocks.
Do not touch the built-in power supply, built-i n grounding or signal wires of the Motion controller
and servo amplifier, as this may lead to electric shocks.
伺服马达 HF-SP102
保护膜 GT15-70PSCB
通用型Q系列CPU Q13UDHCPU
冗余CPU Q12PRHCPU
参数单元 FR-PU07-BB
模块 AJ35PP-CNV-SI
CPU单元 A2UCPU-S1
Melsecnet模块 AJ72P25
输出模块 AY40P
外部连接电缆 GT16H-C30-32P
电源模块 A1S62P
带基板的小点数CPU Q00JCPU-S8-SET
CC-Link IE控制器网络通信单元 GT15-J71GP23-SX
Melsecnet模块 A1SJ71LP21GE
模块 AJ71VP21
冗余电源模块 Q63RP
过程CPU Q02PHCPU
CPU单元 A3NCPUR21
A模式Q系列CPU Q02HCPU-A
伺服马达 HF-SP202B
CPU单元 A2USHCPU-S1
GI-62.5/125光缆型模块 QJ72LP25GE
模块 A6BSW-P-S7
CCLink模块 AJ65BT-D75P2-S3
电源模块 A65P
PT100型温度传感器用适配器 FX3U-4AD-PT-ADP
RS-232通信用 FX3U-232ADP-MB
模块 AJ35PP-CNV
RS-232电缆 GT11H-C30R2-6P
CPU单元 A2CCPU